Ford Fusion: Tire Pressure Monitoring System / Changing Tires With a Tire Pressure Monitoring System

Note: Each road tire is equipped with a tire
pressure sensor located inside the wheel
and tire assembly cavity. The pressure
sensor is attached to the valve stem. The
pressure sensor is covered by the tire and is
not visible unless the tire is removed. Take
care when changing the tire to avoid
damaging the sensor.
You should always have your tires serviced
by an authorized dealer.
Check the tire pressure periodically (at
least monthly) using an accurate tire
gauge. See When Inflating Your Tires in
this chapter.
WARNING: The tire pressure
monitoring system is not a substitute for
manually checking tire pressures. You
should periodically check tire pressures
using a pressure gauge...
The tire pressure monitoring system
measures pressure in your road tires and
sends the tire pressure readings to your
vehicle. You can view the tire pressure
readings through the information display...
Other information:
Overview
NOTICE:
Whenever turbocharger air intake system components are
removed, always cover open ports to protect from debris. It is important
that no foreign material enter the system. The turbocharger compressor
vanes are susceptible to damage from even small particles...
Diagnostic Trouble Code (DTC) Charts
DTC Chart: Powertrain Control Module (PCM)
Diagnostics
in this manual assume a certain skill level and knowledge of
Ford-specific diagnostic practices. For information about these
practices, REFER to: Diagnostic Methods (100-00 General Information, Description and Operation)...