Other information:
Removal
NOTE:
Removal steps in this procedure may contain installation details.
When installing a new RCM,
Programmable Module Installation (PMI) is required. Refer to the
diagnostic scan tool instructions to carry out Programmable Module
Installation (PMI).
WARNING:
Turn the ignition OFF and wait one minute to deplete
the backup power supply. Ignition must re..
Special Tool(s) /
General Equipment
Master Cylinder Bleeding Set
Bleeding
NOTICE:
If the fluid is spilled on the paintwork, the affected area must be immediately washed down with cold water.
Master Cylinder
NOTE:
When a new brake master cylinder has been installed, it
should be primed to prevent air from entering the system.
NOTE:
Make sure the area around the ..