Ford Fusion: Driveline / Rear Drive Halfshafts
Special Tool(s) /
General Equipment
204-161
(T97P-1175-A)
Installer, HalfshaftTKIT-1997-LM2TKIT-1997-F/FM2TKIT-1997-FLM2
205-D070
(D93P-1175-B)
Remover, Front Wheel Hub
Removal
NOTE:
FWD shown AWD is similar...
Preliminary Inspection
Visually inspect the CV joints, housing, boots, and clamps for obvious signs of mechanical damage.
If an obvious cause for an observed or reported concern is
found, correct the cause (if possible) before proceeding to the next
step
If the cause is not visually evident, verify the symptom and REFER to Symptom Chart: NVH...
Other information:
Adjustment
NOTE:
Refer to the appropriate section and procedure for special instructions on loosening and tightening mount fasteners.
Refer to: Jacking and Lifting - Overview (100-02 Jacking and Lifting, Description and Operation).
Loosen, but do not remove, the powertrain/drivetrain mount fasteners...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
The HCU and ABS module are released individually. A new HCU does not come equipped with an ABS module.
All vehicles
Remove the battery tray.
Refer to: Battery Tray (414-01 Battery, Mounting and Cables, Removal and Installation)...