Ford Fusion: Rear Suspension / Rear Suspension - Component Location. Description and Operation

Ford Fusion 2013–2020 Service Manual / Chassis / Suspension / Rear Suspension / Rear Suspension - Component Location. Description and Operation

NOTE: AWD suspension shown, FWD similar.

Ford Fusion. Rear Suspension - Component Location. Description and Operation

Item	Description
1	Coil spring
2	Stabilizer and links
3	Shock absorber
4	Wheel knuckle
5	Wheel bearing and wheel hub assembly
6	Wheel studs
7	Lower arm vertical link
8	Toe link
9	Lower arm and bushing assembly
10	Upper arm
11	Suspension height sensor (If equipped with Dynamic Suspension)
12	Dynamically controlled shock absorber (If equipped with Dynamic Suspension)

Rear Suspension - Overview. Description and Operation

O..

Wheel Bearing and Wheel Hub - AWD. Removal and Installation

Special Tool(s) / General Equipment 205-D070 (D93P-1175-B) Remover, Front Wheel Hub Removal NOTICE: Suspension fasteners are critical parts that affect the performance of vital components and systems...

Other information:

Ford Fusion 2013–2020 Service Manual: Seatbelt Systems. Diagnosis and Testing

Symptom Chart(s) Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation). Preliminary Inspection Before diagnosing or repairing the seatbelt system, inspect the following items: Seatbelt webbing integrity (torn, frayed, cut or stretched) Seat..

Ford Fusion 2013–2020 Owners Manual: Removing a Headlamp

Note: To remove push pins, use a flat-bladed screwdriver to pull up the center release pin. Make sure the headlamp control is in the off position and open the hood. Remove the six push pins securing the front fascia to the front trim cover. Remove the three bumper cover upper screws using a flat-bladed screwdriver. Remove the push pin at the inboard side of the headlamp you are ser..

Understanding Your Tire Pressure Monitoring System

Ford Fusion. Understanding Your Tire Pressure Monitoring System

The tire pressure monitoring system measures pressure in your road tires and sends the tire pressure readings to your vehicle. You can view the tire pressure readings through the information display. The low tire pressure warning light will turn on if the tire pressure is significantly low. Once the light is illuminated, your tires are under-inflated and need to be inflated to the manufacturer’s recommended tire pressure. Even if the light turns on and a short time later turns off, your tire pressure still needs to be checked.