Ford Fusion: Tire Pressure Monitoring System (TPMS) / Tire Pressure Monitoring System (TPMS) - Overview. Description and Operation
Overview
The BCM uses tire pressure sensors to monitor tire pressure. The sensors use radio signals to transmit the tire pressure to the RTM. The RTM sends the information to the BCM over a LIN. The tire pressure sensors are battery operated and mounted to the valve stems. The IPC illuminates the TPMS
warning indicator and the message center displays a message when a
fault is present or when the tire pressure falls below the low pressure
limit.
System Operation
System Diagram
Item
Description
1
IPC
2
BCM
3
IPC message center display
4
TPMS warning indicator
5
LH front TPMS sensor
6
RH front TPMS sensor
7
LH rear TPMS sensor
8
RH rear TPMS sensor
9
RTM
10
GWM
Network Message Chart
RTM
TPMS Network Input M..
Other information:
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the front seat.
Refer to: Front Seat (501-10A Front Seats, Removal and Installation).
Remove the seatbelt buckle.
Disconnect the electrical connector.
Detach the wire harness retainer.
Remove the bolt.
Torque:
26 lb.ft (35 Nm)
..
Overview
Before beginning any service procedure in this manual, refer to health
and safety warnings in section 100-00 General Information. Failure to
follow this instruction may result in serious personal injury.
WARNING:
Before servicing any tire, ask the customer if anyone
injected a tire sealant into the tire. Tire sealants may be flammable
and can burn or explode if exposed..