Ford Fusion: Cruise Control / Using Adaptive Cruise Control (IF EQUIPPED)
WARNING: Pay close attention to changing road conditions such as entering or leaving a highway, on roads with intersections or roundabouts, roads without visible lanes of travel, roads that are winding, slippery, unpaved, or steep slopes.
WARNING: Do not use the system in poor visibility, for example fog, heavy rain, spray or snow.
WARNING: Do not use the system when towing a trailer that has aftermarket electronic trailer brake controls. Failure to follow this instruction could result in the loss of control of your vehicle, personal injury or death.
WARNING: Do not use tire sizes other than those recommended because this can affect the normal operation of the system. Failure to do so may result in a loss of vehicle control, which could result in serious injury.
WARNING: The system may not detect stationary or slow moving vehicles below 6 mph (10 km/h).
WARNING: The system does not detect pedestrians or objects in the road.
WARNING: The system does not detect oncoming vehicles in the same lane.
WARNING: The system is not a crash warning or avoidance system.
The system adjusts your vehicle speed to maintain the set gap between you and the vehicle in front of you in the same lane. You can select four gap settings.
The system uses a radar sensor which projects a beam directly in front of your vehicle.
The cruise controls are on the steering wheel.
- Switching Adaptive Cruise Control On. Setting the Adaptive Cruise Speed. Setting the Adaptive Cruise Speed When Your Vehicle is Stationary
- Following a Vehicle. Following a Vehicle to a Complete Stop
- Setting the Gap Distance
- Overriding the Set Speed. Changing the Set Speed
- Canceling the Set Speed. Resuming the Set Speed. Automatic Cancellation. Park Brake Application
- Hilly Condition Usage. Switching Adaptive Cruise Control Off. Detection Issues
Canceling the Set Speed. Resuming the Set Speed. Cruise Control Indicators.
Canceling the Set Speed
Press the button, or tap the
brake pedal to cancel the set
speed.
Note: The system remembers the set
speed.
Note: The system cancels if the vehicle
speed drops below 10 mph (16 km/h) under
the set speed when driving uphill...
Switching Adaptive Cruise Control On. Setting the Adaptive Cruise Speed.
Setting the Adaptive Cruise Speed When Your Vehicle is Stationary
Switching Adaptive Cruise Control On
For vehicles without Speed
Limiter, press and release the
button.
For vehicles with Speed Limiter,
press and release the button...
Other information:
Ford Fusion 2013–2020 Service Manual: Vehicle Dynamic Suspension - System Operation and Component Description. Description and Operation
System Operation System Diagram Item Description 1 VDM 2 LH front valve solenoid 3 PSCM 4 PCM 5 ABS module 6 LH front height sensor 7 RH front height sensor 8 LH rear height sensor 9 RH rear height sensor 10 BCM 11 RH front valve solenoid 12 LH rear valve solenoid 13 R..
Ford Fusion 2013–2020 Service Manual: Pinpoint Test - DTC: N. Diagnosis and Testing
B0082:11, B0082:12, B0082:13 and B0082:1A Refer to Wiring Diagrams Cell 46 for schematic and connector information. Normal Operation and Fault Conditions The RCM continuously monitors the passenger seatbelt load limiter circuits for the following faults: Resistance out of range Unexpected voltage Short to ground Faulted passenger seatbelt load limiter If a faul..
Categories
- Manuals Home
- 2nd Generation Ford Fusion Owners Manual
- 2nd Generation Ford Fusion Service Manual
- Load Carrying
- Engine - 1.5L EcoBoost (118kW/160PS) – I4
- Engine
- New on site
- Most important about car
Using Seatbelts During Pregnancy
WARNING: Always ride and drive with your seatback upright and properly fasten your seatbelt. Fit the lap portion of the seatbelt snugly and low across the hips. Position the shoulder portion of the seatbelt across your chest. Pregnant women must follow this practice. See the following figure.
