Ford Fusion: Brake System / Anti-Lock Brake System (ABS) and Stability Control

Brake Vacuum Sensor. Removal and Installation

Removal NOTE: Removal steps in this procedure may contain installation details. Remove the battery hold down bolt and plate. Torque: 89 lb...

Anti-Lock Brake System (ABS) and Stability Control - Overview. Description and Operation

Overview The ABS and stability control systems are comprised of the following subsystems which assist the driver in maintaining control of the vehicle: ABS Auto hold Hill start assist EBD ESC Supplemental braking assist Traction control Supports adaptive cruise control Supports collision avoidance Supports electric parking brake ..

Other information:

Ford Fusion 2013–2020 Service Manual: Pinpoint Test - DTC: F. Diagnosis and Testing

B0011:11, B0011:12, B0011:13 and B0011:1A Refer to Wiring Diagrams Cell 46 for schematic and connector information. Normal Operation and Fault Conditions The RCM continuously monitors the passenger airbag stage 2 circuits for the following faults: Resistance out of range Unexpected voltage Short to ground Faulted passenger airbag If a fault is detected, t..

Ford Fusion 2013–2020 Service Manual: SYNC Module [APIM]. Removal and Installation

Removal NOTE: Removal steps in this procedure may contain installation details. Remove the FDIM. Refer to: Front Display Interface Module (FDIM) (415-00 Information and Entertainment System - General Information - Vehicles With: SYNC 3, Removal and Installation). Disconnect the electrical connector. Remove the retainers and separate the APIM. Torque: ..