Ford Fusion: Electronic Engine Controls - 1.5L EcoBoost (118kW/160PS) – I4 / Boost Pressure Sensor. Removal and Installation
Removal
NOTE:
Removal steps in this procedure may contain installation details.
-
Disconnect the electrical connector, remove the retainer and the turbocharger boost pressure sensor.
Torque:
89 lb.in (10 Nm)
Installation
-
To install, reverse the removal procedure.
Removal
NOTE:
When removing any turbocharger air intake system components,
make sure to cover any open ports to prevent debris from entering the
system...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the engine appearance cover.
Disconnect the electrical connectors, remove the bolts and the VCT oil control solenoids...
Other information:
System Operation
System Diagrams
Audio System
*.sttxt {
visibility: hidden;
}
*.stcallout {
visibility: visible;
}
E350726
1
Roof Mounted Antenna
2
APIM
3
BCM
4
ACM
5
DSP
..
Removal
WARNING:
Turn the ignition OFF and wait one minute to deplete
the backup power supply. Ignition must remain OFF until repair is
complete. Failure to follow this instruction may result in serious
personal injury or death in the event of an accidental deployment.
If a SRS fault is present, continue to Step 2. Otherwise, turn the ignition off, wait at least one minute a..