Ford Fusion: Electronic Engine Controls - 1.5L EcoBoost (118kW/160PS) – I4 / Camshaft Position (CMP) Sensor RH. Removal and Installation

Camshaft Position (CMP) Sensor LH. Removal and Installation

Removal NOTE: Removal steps in this procedure may contain installation details. Remove the engine appearance cover. Disconnect the CMP sensor electrical connector, remove the retainer and the CMP sensor...

Catalyst Monitor Sensor. Removal and Installation

Special Tool(s) / General Equipment 303-476 (T94P-9472-A) Socket, Exhaust Gas Oxygen SensorTKIT-1994-LM/MTKIT-1994-FTKIT-1994-FLM/FM Materials Name Specification Motorcraft® High Temperature Nickel Anti-Seize LubricantXL-2 -  Motorcraft® Penetrating and Lock LubricantXL-1 -  Removal Disconnect the catalyst monitor sensor electrical co..

Other information:

Ford Fusion 2013–2020 Owners Manual: Engine Block Heater (IF EQUIPPED)

WARNING: Failure to follow engine block heater instructions could result in property damage or serious personal injury. WARNING: Do not use your heater with ungrounded electrical systems or two-pronged adapters. There is a risk of electrical shock. Note: The heater is most effective when outdoor temperatures are below 0°F (-18°C). The heater acts as a starting aid by warming the engine ..

Ford Fusion 2013–2020 Service Manual: Halfshaft Seal LH. Removal and Installation

Special Tool(s) / General Equipment 205-153 (T80T-4000-W) Handle 307-626Installer, Differential SealTKIT-2008ET-FLMTKIT-2008ET-ROW Puller Punch Removal Remove the LH halfshaft. Refer to: Front Halfshaft LH (205-04 Front Drive Halfshafts, Removal and Installation). Poke a small hole in the halfshaft seal. Use the General Equipment: Pu..