Ford Fusion Manuals

Ford Fusion: Electronic Engine Controls - 1.5L EcoBoost (118kW/160PS) – I4 / Electronic Engine Controls - Overview. Description and Operation

Overview

The EEC system provides optimum control of the engine through the enhanced capability of the powertrain control module (PCM). The EEC system also has an on board diagnostic (OBD) monitoring system with features and functions to meet federal regulations on exhaust emissions.

The EEC system has two major divisions: hardware and software. The hardware includes the PCM, sensors, switches, actuators, solenoids, and interconnecting terminals. The software in the PCM provides the strategy control for outputs (engine hardware) based on the values of the inputs to the PCM.

The PCM receives information from a variety of sensor and switch inputs. Based on the strategy and calibration stored within the PCM, the PCM generates the appropriate output. The system is designed to minimize emissions and optimize fuel economy and driveability. The software strategy controls the basic operation of the engine, provides the OBD strategy, controls the malfunction indicator lamp (MIL), communicates to the scan tool over the data link connector (DLC), allows for flash electrically erasable programmable read only memory (EEPROM), provides idle air and fuel trim, and controls failure mode effects management (FMEM).

    Specifications

    ..

    Electronic Engine Controls - Component Location. Description and Operation

    Electronic Engine Controls - LH Item Description 1 PCM 2 VCT oil control solenoid intake 3 MAPT sensor 4 KS front 5 CAC coolant temperature sensor 6 KS rear 7 IAT sensor 8 Crankcase pressure sensor 9 Turbocharger boost pressure sensor 10 IAT2 11 CMP sensor LH intake 12 FRP se..

    Other information:

    Ford Fusion 2013–2020 Service Manual: Pinpoint Test - DTC: E. Diagnosis and Testing


    B0010:11, B0010:12, B0010:13 and B0010:1A Refer to Wiring Diagrams Cell 46 for schematic and connector information. Normal Operation and Fault Conditions The RCM continuously monitors the passenger airbag stage 1 circuits for the following faults: Resistance out of range Unexpected voltage Short to ground Faulted passenger airbag If a fault is detected, t..

    Ford Fusion 2013–2020 Service Manual: Module Configuration - System Operation and Component Description. Description and Operation


    System Operation Module Programming Menu Module Programming is listed under the Toolbox tab after starting an IDS session with a vehicle. The module programming menu is disabled when a manual vehicle session is created. The Module Programming menu has 4 selections: Programmable Module Installation (PMI) Module Reprogramming Programmable Parameters As-Built These selec..

    Categories

    Cross Traffic Alert System Sensors

    Ford Fusion. Cross Traffic Alert System Sensors

    The sensors are behind the rear bumper on both sides of your vehicle.

    read more

    Copyright © 2024 www.fofusion2.com