Other information:
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
If installing a new module, it is necessary to
upload the module configuration information to the scan tool prior to
removing the module. This information must be downloaded into the new
module after installation...
B0010:11, B0010:12, B0010:13 and B0010:1A
Refer to Wiring Diagrams Cell 46 for schematic and connector information.
Normal Operation and Fault Conditions
The RCM continuously monitors the passenger airbag stage 1 circuits for the following faults:
Resistance out of range
Unexpected voltage
Short to ground
Faulted passenger airbag
If a fault is detected, t..