Ford Fusion Manuals

Ford Fusion: Roadside Emergencies / Hazard Flashers. Fuel Shutoff

Hazard Flashers

Note: The hazard flashers operate when the ignition is in any position, or if the key is not in the ignition. If used when the vehicle is not running, the battery loses charge. As a result, there may be insufficient power to restart your vehicle.

Ford Fusion. Hazard Flashers. Fuel Shutoff The flasher control is on the instrument panel. Use your hazard flashers when your vehicle is creating a safety hazard for other motorists.

  • Press the flasher control and all front and rear direction indicators flash.
  • Press the button again to switch them off.

Fuel Shutoff

WARNING: If your vehicle has been involved in a crash, have the fuel system checked. Failure to follow this instruction could result in fire, personal injury or death.

Note: When you try to restart your vehicle after a fuel shutoff, the vehicle makes sure that various systems are safe to restart. Once the vehicle determines the systems are safe, then the vehicle allows you to restart.

Note: In the event that your vehicle does not restart after your third attempt, contact a qualified technician.

The fuel pump shutoff stops the flow of fuel to the engine in the event of a moderate to severe crash. Not every impact causes a shutoff.

Should your vehicle shut off after a crash, you may restart your vehicle.

  1. If your vehicle has a key system:
  2. Switch off the ignition.
  3. Switch to start position.
  4. Switch off the ignition.
  5. Switch on the ignition to re-enable the fuel pump.
  6. If the vehicle does not start, repeat steps 1 through 4.

If your vehicle has a push button start system:

  1. Press START/STOP to switch off your vehicle.
  2. Press the brake pedal and START/STOP to switch on your vehicle.
  3. Remove your foot from the brake pedal and press START/STOP to switch off your vehicle.
  4. You can attempt to start the vehicle by pressing the brake pedal and START/STOP, or press START/STOP without pressing the brake pedal.
  5. If the vehicle does not start, repeat steps 1 through 4.

    Roadside Assistance

    Vehicles Sold in the United States: Getting Roadside Assistance To fully assist you should you have a vehicle concern, Ford Motor Company offers a complimentary roadside assistance program...

    Jump Starting the Vehicle

    WARNING: Batteries normally produce explosive gases which can cause personal injury. Therefore, do not allow flames, sparks or lighted substances to come near the battery...

    Other information:

    Ford Fusion 2013–2020 Service Manual: SYNC Module [APIM] to Universal Serial Bus (USB) Port Cable. Removal and Installation


    Special Tool(s) / General Equipment Interior Trim Remover Removal NOTE: Removal steps in this procedure may contain installation details. Instrument panel cable Remove the FDIM. Refer to: Front Display Interface Module (FDIM) (415-00 Information and Entertainment System - General Information - Vehicles With: SYNC 3, Removal and Installation)...

    Ford Fusion 2013–2020 Service Manual: Cylinder Bore Taper. General Procedures


    Check NOTE: Refer to the appropriate Section 303-01 for the specification. Measure the cylinder bore at the top, middle and bottom of piston ring travel in 2 directions as indicated. Verify the cylinder bore is within the wear limit. The difference indicates the cylinder bore taper...

    Categories

    Adjusting the Steering Wheel

    WARNING: Do not adjust the steering wheel when your vehicle is moving.

    Note: Make sure that you are sitting in the correct position.

    Ford Fusion. Adjusting the Steering Wheel

    Unlock the steering column. Adjust the steering wheel to the desired position.

    read more

    Copyright © 2024 www.fofusion2.com