Ford Fusion: Body and Paint / Interior Trim and Ornamentation

Rear Door Check Arm. Removal and Installation

Removal NOTE: Left hand (LH) side shown, right hand (RH) side similar. Remove the door trim panel and water shield. Refer to: Rear Door Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation)...

A-Pillar Trim Panel. Removal and Installation

Removal NOTE: RH side shown, LH side similar. Release the retainers and remove the instrument panel side trim panel. Position aside the front door weatherstrip...

Other information:

Ford Fusion 2013–2020 Service Manual: Climate Control Housing - Vehicles With: Dual Automatic Temperature Control (DATC). Removal and Installation

Removal NOTE: Removal steps in this procedure may contain installation details. Remove the instrument panel upper section. Refer to: Instrument Panel Upper Section (501-12 Instrument Panel and Console, Removal and Installation). Detach the wiring harness retainer, remove the nuts and the instrument panel upper brace...

Ford Fusion 2013–2020 Service Manual: Factory Mode Deactivation. General Procedures

Deactivation NOTE: During vehicle build, some modules, such as the IPC and BCM module are set in factory mode. Factory mode reduces the drain on the battery during longer periods where the vehicle is not used. While in the factory mode, various systems may be altered or disabled and the IPC displays FACTORY MODE CONTACT DEALER in the message center...