You can use the power door lock control
or the remote control to lock and unlock
your vehicle.
Other information:
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the battery hold down bolt and plate.
Torque:
89 lb.in (10 Nm)
Position the battery forward.
Disconnect the brake vacuum sensor electrical connector...
B0010:11, B0010:12, B0010:13 and B0010:1A
Refer to Wiring Diagrams Cell 46 for schematic and connector information.
Normal Operation and Fault Conditions
The RCM continuously monitors the passenger airbag stage 1 circuits for the following faults:
Resistance out of range
Unexpected voltage
Short to ground
Faulted passenger airbag
If a fault is detected, t..