Ford Fusion: Fuel System - General Information / Acceleration Control

Fuel Level Sender. Removal and Installation

Removal NOTE: Removal steps in this procedure may contain installation details.   WARNING: Before beginning any service procedure in this section, refer to Safety Warnings in section 100-00 General Information...

Acceleration Control - Overview. Description and Operation

Overview The acceleration controls consist of the accelerator pedal and sensor assembly. The throttle is controlled by an APP sensor on the accelerator pedal assembly...

Other information:

Ford Fusion 2013–2020 Service Manual: Variable Camshaft Timing (VCT) Unit. Removal and Installation

Special Tool(s) / General Equipment 303-1097Locking Tool, Variable Camshaft Timing Oil Control UnitTKIT-2010B-FLMTKIT-2010B-ROW 303-1552Alignment Tool, CamshaftTKIT-2012A-FLTKIT-2012A-ROW Hot Air Gun Hose Clamp Remover/Installer Materials Name Specification Flange SealantCU7Z-19B508-A WSS-M2G348-A11  Motorcraft® Metal Surface Prep WipesZC-31-B -&..

Ford Fusion 2013–2020 Owners Manual: Removing a Headlamp

Note: To remove push pins, use a flat-bladed screwdriver to pull up the center release pin. Make sure the headlamp control is in the off position and open the hood. Remove the six push pins securing the front fascia to the front trim cover. Remove the three bumper cover upper screws using a flat-bladed screwdriver. Remove the push pin at the inboard side of the headlamp you are ser..