Ford Fusion: Powertrain / Fuel System - General Information

Muffler and Tailpipe. Removal and Installation

Removal NOTE: Removal steps in this procedure may contain installation details. With the vehicle in NEUTRAL, position it on a hoist. Refer to: Jacking and Lifting - Overview (100-02 Jacking and Lifting, Description and Operation)...

Fuel System - General Information - 1.5L EcoBoost (118kW/160PS) – I4

..

Other information:

Ford Fusion 2013–2020 Service Manual: Rear Door Check Arm. Removal and Installation

Removal NOTE: Removal steps in this procedure may contain installation details. NOTE: LH shown, RH similar. Remove the rear check arm bolt. Torque: 18 lb.ft (25 Nm) Remove the rear door trim panel. Refer to: Rear Door Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation). Disconnect the electrical conn..

Ford Fusion 2013–2020 Service Manual: Cylinder Block Distortion. General Procedures

Special Tool(s) / General Equipment Feeler Gauge Check NOTE: Refer to the appropriate Section 303-01 for the specification. NOTE: Use a Straightedge that is calibrated by the manufacturer to be flat within 0.005 mm (0.0002 in) per running foot of length, such as Snap-On® GA438A or equivalent. For example, if the Straightedge is 61 cm (24 in) long, the machined edge m..