Ford Fusion: Rear Drive Axle/Differential / Specifications

Rear Drive Axle/Differential

..

Rear Drive Axle and Differential. Diagnosis and Testing

Preliminary Inspection Visually inspect the housing, seals, and pinion flange for obvious signs of mechanical damage. If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step If the cause is not visually evident, verify the symptom and REFER to Symptom Chart: NVH...

Other information:

Ford Fusion 2013–2020 Service Manual: Cylinder Block Distortion. General Procedures

Special Tool(s) / General Equipment Feeler Gauge Check NOTE: Refer to the appropriate Section 303-01 for the specification. NOTE: Use a Straightedge that is calibrated by the manufacturer to be flat within 0.005 mm (0.0002 in) per running foot of length, such as Snap-On® GA438A or equivalent...

Ford Fusion 2013–2020 Service Manual: Restraints Control Module (RCM). Removal and Installation

Removal NOTE: Removal steps in this procedure may contain installation details. When installing a new RCM, Programmable Module Installation (PMI) is required. Refer to the diagnostic scan tool instructions to carry out Programmable Module Installation (PMI)...