Ford Fusion: Wipers and Washers / Windshield Washers

Ford Fusion 2013–2020 Owners Manual / Wipers and Washers / Windshield Washers

Ford Fusion. Windshield Washers

Ford Fusion. Windshield Washers Pull the lever toward you to operate the windshield washers.

When you release the lever, the wipers operate for a short time. When activated, a courtesy wipe occurs a short time after the wipers stop to clear any remaining washer fluid.

Note: You can switch courtesy wipe on or off in the information display.

Note: Do not operate the washers when the washer reservoir is empty. This could cause the washer pump to overheat.

Front Camera Washer (If Equipped)

Operating the windshield washer also turns on the front camera washer.

Autowipers (IF EQUIPPED)

Note: Fully defrost the windshield before you switch the windshield wipers on. Note: Make sure that you switch the windshield wipers off before entering a car wash...

Other information:

Ford Fusion 2013–2020 Service Manual: Factory Mode Deactivation. General Procedures

Deactivation NOTE: During vehicle build, some modules, such as the IPC and BCM module are set in factory mode. Factory mode reduces the drain on the battery during longer periods where the vehicle is not used. While in the factory mode, various systems may be altered or disabled and the IPC displays FACTORY MODE CONTACT DEALER in the message center. If the vehicle is in factory mod..

Ford Fusion 2013–2020 Service Manual: Front Parking Aid Sensor. Removal and Installation

Removal NOTE: Removal steps in this procedure may contain installation details. All Sensors Remove the front bumper cover. Refer to: Front Bumper Cover (501-19 Bumpers, Removal and Installation). Outer front parking aid sensors Remove the outer front parking aid sensor. Disconnect the outer front parking aid sensor electrical connector. Re..

Manual Climate Control

Ford Fusion. Manual Climate Control

Note: Depending on your vehicle option package, the controls may look different from what you see here.