Ford Fusion: Climate Control System - General Information / Air Inlet Door Actuator. Removal and Installation
Removal
NOTE:
Removal steps in this procedure may contain installation details.
-
WARNING:
Before beginning any service procedure in this
section, refer to Safety Warnings in section 100-00 General Information.
Failure to follow this instruction may result in serious personal
injury.
Refer to: Climate Control System Health and Safety Precautions (100-00 General Information, Description and Operation).
-
Remove the instrument panel.
Refer to: Instrument Panel (501-12 Instrument Panel and Console, Removal and Installation).
-
Disconnect the electrical connector, remove the retainers and the air inlet door actuator.
Installation
-
To install, reverse the removal procedure.
Removal
NOTE:
Removal steps in this procedure may contain installation details.
WARNING:
Before beginning any service procedure in this
section, refer to Safety Warnings in section 100-00 General Information...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
All vehicles
With the vehicle in NEUTRAL, position it on a hoist...
Other information:
Repair
NOTE:
Mouldings located on the front and rear window frames may
experience minor scratches from vehicle shipment or car wash racks. The
imperfections may be repaired instead of replacing components by
following the steps below.
NOTE:
Scratches deep enough to cause a thumb nail to catch cannot be repaired and the component must be replaced...
Symptom Chart(s)
Symptom Chart: Symptom Chart - Exhaust System
Verify
the customer concern. Inspect the components of the exhaust system for
obvious signs of damage or other mechanical concerns using the following
chart.
Visual Inspection Chart - Mechanical
Mechanical
Exhaust pipe pinched or crushed
Damaged muffler
Broken or damaged..