Other information:
Line Pressure Test
NOTE:
Perform the line pressure test prior to performing the stall
speed test. If the line pressure is low at stall, do not perform the
stall speed test or transmission damage will occur. Do not maintain WOT in any transmission range for more than 5 seconds.
This test verifies the line pressure is within specification.
Remove the 2 bolts and position aside the air..
Inspection
WARNING:
All seatbelt components must be inspected and corrected as
part of any collision repair. Inspect all seatbelt components as
prescribed by Seatbelt Procedure After a Collision found in Section
501-20A General Procedures of this manual. Failure to follow this
instruction may result in incorrect operation of the seatbelt system and
increase the risk of serious per..