Other information:
Check
NOTE:
Refer to the appropriate Section 303-01 for the specification.
Measure the piston diameter 90 degrees from the piston
pin and 41 mm (1.61 in) down from the top of the piston at the point
indicated.
..
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the rear seat cushion.
Refer to: Rear Seat Cushion (501-10B Rear Seats, Removal and Installation).
Remove the rear RH and center seatbelt buckle.
Disconnect the electrical connector.
Detach and disconnect the electrical connector.
Remove the bolt.
Torq..