Ford Fusion: Body and Paint / Roof Opening Panel

Windshield Wiper Pivot Arm. Removal and Installation

Special Tool(s) / General Equipment Two Leg Puller Removal NOTE: LH side shown, RH side similar. Remove the wiper pivot arm nut cover and remove the wiper pivot arm nut...

Specifications

Item Specification Roof opening panel glass clearance-front edge -0.059 – 0.00 in (-1.5 – 0.0 mm) Roof opening panel glass clearance-rear edge 0...

Other information:

Ford Fusion 2013–2020 Service Manual: Pinpoint Test - DTC: H. Diagnosis and Testing

B0050:11, B0050:12, B0050:13 and B0050:1D Refer to Wiring Diagrams Cell 46 for schematic and connector information. Normal Operation and Fault Conditions The RCM monitors the driver seatbelt buckle switch circuits for the following faults: Open circuit Short to voltage Short to ground Current out of range Faulted driver seatbelt buckle switch If ..

Ford Fusion 2013–2020 Service Manual: Factory Mode Deactivation. General Procedures

Deactivation NOTE: During vehicle build, some modules, such as the IPC and BCM module are set in factory mode. Factory mode reduces the drain on the battery during longer periods where the vehicle is not used. While in the factory mode, various systems may be altered or disabled and the IPC displays FACTORY MODE CONTACT DEALER in the message center. If the vehicle is in factory mod..